Making The Electrical Connections - Modern Forms VORTEX FR-W1810 Installation Instructions Manual

10. MAKING THE ELECTRICAL CONNECTIONS

REMEMBER to disconnect the power by removing fuses or turning off circuit breakers.
Follow the steps below to hang your fan properly:
WARNING: To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
WARNING: Installation of this fan requires that a
three-conductor cable (including ground wire) which should run be-
tween ceiling and wall outlet box.
WARNING: Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire nuts, except for the
ground wire.
Insert the receiver into the mounting bracket with the flat side of the
receiver facing the ceiling. (Fig 12)
Follow the steps on the next page to connect the fan to your
household wiring. Use the included plastic wire nuts with your fan.
Secure the plastic wire nuts with electrical tape. Make sure there are
no loose strands or
connections.
FR - W 1 8 10
Receiver
FIGURE 14
Mounting
bracket
13