Cleaning Your Infinea X; Cleaning Precautions - Infinite Peripherals Infinea X User Manual

CLEANING YOUR INFINEA X

Cleaning Precautions

The Infinea X is certified to meet IP54 Ingress Protection Marking per IEC 60529.
Per the IP54 rating, the Infinea X is protected against interference with normal
operation of the Infinea X sled caused by dust and splashing liquids. At no time
should the Infinea X sled be completely immersed in liquid. Total submersion
of the device may allow liquid to enter the unit and impair its normal function.
Immersion will also void the Infinea X warranty.
The end user should determine an appropriate cleaning procedure that complies
with any facility and/or industry-specific cleaning requirements. The following
information is a general cleaning guideline that should be followed to ensure the
Infinea X maintains its normal operation.
Cleaning Guidelines
• Do NOT autoclave, machine wash, pressure-sterilize or gas-sterilize the Infinea X.
• Do NOT soak or immerse in any liquid.
• Clean the Infinea X only when the battery module is properly installed and
locked into the Infinea X. This will ensure proper sealing of the Infinea X prior to
introducing any solutions and/or wipes used during the cleaning process.
• Apply cleaning solutions with a soft lint-free cloth. If the solution comes in
the form of a wipe, ensure the wipe is lint-free and will not scratch the plastic
surfaces (especially the scan window). Excessive solution that resides in any of
the waterproof membrane orgasket areas can seep into the devices and cause
damage to the internal components.
• Do not touch, press or rub the display and/or covers with abrasive cleaning
compounds, instruments, brushes, rough surface material or bring the display
and/or covers into contact with products that could potentially scratch the
display or covers.
• To clean the Infinea X screw areas, use a soft-bristled brush with approved
cleaning solutions. Focus cleaning in the screw areas, ensuring that the brush is
not used in areas that contain seals or gaskets.
• Do not use ammonia based, petroleum-based or acetone cleaning solutions to
clean the Infinea X. Also avoid harsh solvents.
• Use the following cleaning solutions only to clean the Infinea X exterior surfaces:
• Clorox® Bleach (10%)
• Isopropyl Alcohol Wipes (70%)
Page 26