Programmable Options - Infinite Peripherals Infinea X User Manual

PROGRAMMABLE OPTIONS

Below are some optional settings for the Infinea X which can be configured via
the SDK.
Programmable
Options
Set Charging
Charging Current
Scan Mode
Pass Through Sync
Time Out
Enables or disables battery backup sharing capability to charge
the iOS device from the IX removable battery.
Charging current may be set to 500mA or 1A. Default setting is
1A.
The Infinea X supports the following Scan modes:
• Single Scan
Scanning a single barcode by pressing the Scan button.
• Multi Scan
Scanning multiple barcodes by pressing and holding the
Scan button.
• Motion-Detect
Scanner is activated automatically when barcode is placed
near the barcode engine.
• Multi-Scan without Duplicates
Scanning multiple barcodes without duplicates.
When the pass through sync setting is enabled and the Charging
Cup is plugged in to the wall outlet, the iOS device may be
synced with a PC or MAC. Default setting is "OFF".
Note: If Pass Through Sync is enabled, the iOS device will not
charge when plugged into an external charger.
Set timeout for 60 or up to 64800 seconds (18 hrs.).
Note: Default setting is subject to change for this feature based
on specific use or integration.
Description
Page 10