Charging The Infinea X; Battery Status - Infinite Peripherals Infinea X User Manual

CHARGING THE INFINEA X

There are two options for charging the Infinea X:
• By wall outlet
• By replacing battery
The Infinea X supports pass through charging to the iOS device. The iPhone
together with the Infinea X may be charged by attaching the Charging Cup to the
bottom of the Infinea X and the USB end into an AC wall adapter. Due to charging
requirements, the Infinea X and iPhone cannot be charged togther using a USB
cable to PC connection.

Battery Status

To check the battery life of the Infinea X device, press either of the Battery Status
buttons on the bottom left or right side of the device.
If the green LED does not light up on the Infinea X device while charging, verify
the USB connector is properly connected and the device is seated securely in
the Charging Cup accessory. If the problem persists, contact Infinite Peripherals
Technical Support for assistance.
100%-75%
74%-50%
49%-25%
24%-10%
9%-1%
When remaining battery capacity is below 15%, the automatic charge of the iOS
device stops.
The Infinea X standard battery has a capacity of 1,900 mAh. The extended battery
pack (sold separately) offers a capacity of 3,800 mAh.
Battery Status
LEDs are solid green upon pressing the Battery Status button.
LEDs flash green upon pressing the Battery Status button.
LEDs flash orange upon pressing the Battery Status button.
LEDs flash red upon pressing the Battery Status button.
One LED automatically flashes red to indicate emergency low
battery status.
Page 17