Altronic CPU-95 Operating Instructions Manual page 13

6.4 The next mode selection can increase or decrease the one-step retard value.
The first screen below is displayed when one-step retard is both configured
and is active. The second screen below is displayed when the one-step retard
is configured but not active. The default configuration selects one-step retard
to be controlled by the Misc. Input terminal. The additional retard would be
implemented when the input is grounded. The third screen below is displayed
when the one-step retard feature is not configured. The actual engine timing
is displayed on this screen so the effect of 1 step retard can be seen during
adjustments (if the Misc Input terminal is grounded).
AT THE
NEXT
OPTION
SCREEN
OR
OR
TO TO
INCREASE DECREASE
CPU-95EVS OI 7-13
All rights reserved © ALTRONIC, LLC 2013
NOTE: UPPER CASE
1 STEP RET = ON.
NOTE: LOWER CASE
1 STEP RETARD = OFF.
NOTE: 1 STEP RETARD
NOT CONFIGURED.
TO GO TO
NEXT
BACK TO EXIT
FIRST
13
ESC