Table of Contents
Advertisement
Place the assembled BigRide slide on the deck relative to the pool wall. Ensure that the exit
1.
flume clears any coping. Slide may be angled slightly providing all dimensions are maintained as
noted in the Manufacturer's Placement Instructions noted in the following section.
THE PVC LEGS ARE NOT MEANT AS THE SUPPORT STRUCTURE FOR THE SLIDE. The
2.
BigRide is designed as a landscape slide and should be installed by a professional. The
PVC legs are only designed to be used for placement and installation, and may not be
used as the slides primary means of support.
If use of the PVC legs is desired, place the corresponding leg in to each of the numbered sockets
3.
from FIGURE F. (The left hand slide is shown, for a right hand slide the legs are the same length
but will be placed on the opposite side of the slide.)
Level slide in two perpendicular positions from the seat of the top platform. Adjust the legs until
4.
the slide is level. Then drill a hole through the existing hole in the PVC sockets and into the PVC
leg. Then tighten the self tapping screw (6) through both pieces of PVC. Do this with the longer
legs first, and then continue towards the exit section of the slide.
INSTALLATION INSTRUCTIONS
9
FIGURE F
– Location sockets
Advertisement
Table of Contents
