Table of Contents
Advertisement
2.6.2 Firmware Operation Mode
In the operation mode, users need to set the dip-switch to the
"Normal" position as Figure 2-16 and reset the power. The GW-7228 can
run in the operation mode. In this mode, users can use the Modbus
Master command to set / get J1939 messages via COM port.
Figure 2-16: Normal Position of Dip-Switch
GW-7228 J1939/Modbus RTU Slave Gateway User's Manual (Ver 1.3, Apr/2011) ------------- 16
Advertisement
Table of Contents
