Alcatel I series User Manual page 18

66
Installation and
start-up
• The machines must be connected to an electrical installation in compliance
with decree 88-1056 dated 14th November 1988, as well as any local
electrical codes that apply.
• It is important to isolate the machine from the power source before any
intervention on the equipment (for maintenance purposes).
• When switching off the power of equipment containing capacitors loaded
with over 60 VDC or 25 VAC, take precautions when accessing the connector
pins (single-phase motors, equipment with mains filter, frequency converter,
monitor, etc.).
• Vane roughing pumps use lubricants, it is recommended to request
information from the manufacturer on the safety data sheets concerning the
product used.
• Our pumps are tested in the factory with ALCATEL 120 oil or Alcatel 119
for the USA (Alcatel 113 oil for the C2series).
It
is recommended to use the
same oil during operation.
If
changing the type of oil, refer to the chapter concerned for the procedure
and the type of lubricant required.
• Our pumps are designed to prevent any thermal risk for user safety.
However, specific operating conditions may generate temperatures which may
justify particular attention on the part of the user (outer surfaces> 70°e).
,
')
j