IM PORTANT: If you have multiple remotes, please follow
the steps below to pair all remotes to the same Pow erView
Netw ork. If you only have one remote, please refer to page 19
for additional programming steps.
P a i r i n g a d d i t i o n a l r e m o t e ( s ) t o t h e
P o w e r V i e w
®
S h a d e N e t w o r k
Follow these steps to pair remotes to the same Pow erView
Shade Netw ork. All rem ot es in a home should be paired to
the same netw ork. This allow s for easy installation of additional
control options, such as the Pow erView Hub and Pow erView
Repeaters. Remotes paired to the same netw ork w ill be able
to operate the speci c w indow coverings they are assigned to.
1 .
Locate the programming access on the back cover of
the remote module.
2 .
Using a paper clip, press and hold the recessed P button
for 6 seconds.
NOTE: The Group Numbers (1– 6) w ill ash tw ice on the
PRESS of the reset button followed by three times at
6 seconds.
3 .
Press and hold
buttons blink. The remote is now in program mode.
4 .
Press and hold the
w hile pressing and releasing
5 .
The backlit GROUP buttons on the new remote w ill ash
tw ice to indicate the remote has been paired to the
Pow erView Shade Netw ork.
6 .
Press and hold
lights stop blinking to exit program mode.
1 4
®
STOP on the remote, until the indicator
STOP button on the new remote
STOP on the original remote.
STOP on the remote, until the indicator
P a i r i n g P o w e r V i e w
®
R e p e a t e r s
t o a r e m o t e c r e a t e d P o w e r V i e w
S h a d e N e t w o r k
Repeaters extend the range of the radio frequency (RF)
signal emitted by the Pow erView
®
Pebble
Pow erView Surface, or the PowerView Hub w hen used with
the PowerView App.
1 .
PLUG the Repeat er Kit into an elect rical out let .
2 .
Press and hold
STOP on the Pow erView Pebble
Remote, until the indicator lights blink. The remote
is now in program mode.
Hold the remote w ithin 3 feet of the Repeater to
complete Step 3.
3 .
Press
STOP on the remote. The Repeater is now
paired to the Pow erView Shade Netw ork.
4 .
Press and hold
STOP on the remote, until the
indicator lights stop blinking to exit program mode.
®
Remote, the
1 5
Need help?
Do you have a question about the PowerView Motorization and is the answer not in the manual?