Hunter Douglas PowerView Motorization Manual page 10

P a i r i n g r e m o t e ( s ) t o a P o w e r V i e w
c r e a t e d P o w e r V i e w S h a d e N e t w o r k
A Hub previously paired to an existing remote created
Pow erView ® Shade Netw ork or that had created its ow n
netw ork during setup, can have additional Pebble
remotes paired to it, even if the remotes are introduced after
the initial Hub setup. The repeater's green light w ill ash,
w henever it repeats a command sent by a device on the
same Pow erView Shade Netw ork.
1 .
Locate the programming access on the back cover of
the remote module.
2 .
Using a paper clip, press and hold the recessed P button
for 6 seconds.
NOTE: The Group Numbers (1–6) w ill ash tw ice on
the PRESS of the reset button follow ed by three times
at 6 seconds.
3 .
Hold the rem ot e m odule w ithin approximately
12 inches of the Hub.
Com plet e St eps 4 and 5 at t he sam e t im e.
4 .
Press and hold the
5 .
Press and hold the
for approximately three seconds.
NOTE: The Group Numbers (1–6) w ill ash to indicate
that the remote module has been paired to the
Pow erView Shade Netw ork.
1 6
® H u b
or Surface
®
STOP button on the remote module.
button on the back of the Hub
P
C r e a t i n g a D u p l i c a t e R e m o t e
A duplicate remote w ill operate the same set of w indow
coverings and GROUPS as the original remote.
1 .
Locate the programming access on the back cover of
the remote module.
2 .
Using a paper clip, press and hold the recessed P button
for 6 seconds.
NOTE: The Group Numbers (1–6) w ill ash tw ice on the
PRESS of the reset button follow ed by three times at
6 seconds.
3 .
Press and hold STOP on the original remote, until
the indicator lights blink. The remote is now in
program mode.
4 .
While pressing and holding ALL on the new remote,
press and release STOP on the original remote.
5 .
The backlit GROUP buttons on the duplicat e remote
w ill ash tw ice to indicate all of the information from
the original remote has been copied.
6 .
Press and hold STOP on the original remote, until
the indicator lights stop blinking to exit program mode.
1 7