Advertisement
Available languages
Available languages
ForSafe Useof YourGrill and to Avoid Serious
Injury:
• Do not let children operate or play near grill.
• Keep grill area clear and free from materials that
burn.
• Do not block holes in sides or back of grill.
• Use grill only in well-ventilated
space. NEVER use
in enclosed space such as carport,
garage,
porch, covered
patio, or under an overhead
structure of any kind.
• Do not use charcoal or ceramic briquets in a gas
grill.
• Use grill at least 3 ft. from any wall or
surface.
Maintain 10 ft. clearance to objects that can
catch fire, or to sources of ignition such as pilot
lights on water heaters, live electrical
appliances,
etc.
• Apartment
Dwellers:
Check with management to learn the
requirements and fire codes for using an LPgas
grill in your apartment complex. If allowed, use
outside on the ground floor with a three (3) foot
clearance
from walls or rails. Do not use on or
under balconies.
• NEVER attempt to light burner with lid closed. A
buildup of non-ignited gas inside a closed grill is
hazardous.
• Never operate grill with LPcylinder out of
correct
position specified in assembly instructions.
• Always close LPcylinder valve and remove
coupling nut before moving LPcylinder from
specified operation
position.
• Charcoal
grill
• Do not remove adjustable charcoal
pan while
ashes and charcoal are HOT.
• Air dampers are HOT while the grill is in use and
during cooling; wear protective
gloves when
adjusting.
• Never overfill
charcoal
pan. This can cause
serious injury as well as damage
the unit.
• Only
use charcoal
lighting
fluid;
NEVER use
gasoline,
alcohol
or other highly
volatile
fluids to ignite the charcoal.
These fluids can
explode
causing
injury or death.
Safety
Tips
ABefore opening LPcylinder valve, check the coupling nut for tightness.
AWhen grill is not in use, turn off all control knobs and LPcylinder valve.
ANever
move grill while in operation or still hot.
AUse long handled barbecue utensilsand oven mitts to avoid burnsand
splatters.
AMaximum load for sideburner and side shelf is 10 Ibs.
AThe grease tray must be inserted into grill and emptied after each use. Do
not remove grease tray until grill has completely cooled.
AClean grill often, preferably after each cookout. If a bristle brush is used to
dean any of the grill cooking surfaces,ensureno loose bristles remain on
cooking surfacesprior to grilling. It is not recommended to dean cooking
surfaces while grill is hot.
Alf you notice grease or other hot material dripping from grill, determine the
cause, correct it, then clean and inspect valve. Keep ventilation openings in
cylinder enclosure (grill cart) free and clear of debris.
ADo not store objects or materials inside the grill cart enclosure that would
block the flow of combustion air to the underside of either the control panel
or the firebox bowl.
AThe regulator may make a hummingor whistling noise during operation. This
will not affect safety or use of grill
Aif you have a grill problem see the "Troubleshooting Section".
AIf the regulator frosts, turn off grill and LPcylinder valve immediately. This
indicates a problem with the cylinder and it should not be used on any
product. Returnto supplier!
AFor appliances designed to use a CGA791 Connection: "Place dust cap on
cylinder valve outlet whenever the cylinder is not in use. Only install the type
of dust cap on the cylinder valve outlet that is provided with the cylinder
valve. Other types of caps or plugs may result in leakage of propane.
CAUTION
• Putting out grease fires by closing the lid is not
possible. Grills are well ventilated for safety
reasons.
• Do not use water on a grease fire. Personal injury
may result. If a grease fire develops, turn knobs
and LP cylinder off.
• Do not leave grill unattended while preheating or
burning off food residue on HI. If grill has not
been regularly cleaned, a grease fire can occur
that may damage the product.
Main
Burner
Igniter
Lighting
ADo not lean over grill while lighting.
1. Open lid during lighting.
2. Turn on valve from source or tank.
3. To ignite, turn Ignition Burner knob to HI.
4. Pushand hold electronic ignition button. You will hear a clicking
sound from the electrodes.
5. If ignition does not occur in 5 seconds, turn the burner controls
OFF, wait 5 minutes,and repeat the lighting procedure.
6. To ignite any other Main Burner, turn knob to HI.
7. To ignite the Side Burner, follow steps 3-5 using the Side Burner
knob.
If igniter does not work, follow Match Lighting instructions.
23671-46477279
" 7
Advertisement
