Advertisement
Available languages
Available languages
TroubJeshoofing
- EJectronJc Ignition
SECTION I
No sparks appear at
any electrodes when
control knob turned
to HI: no noise can
be heard from spark
module.
SECTION II
No sparks appear at
any electrodes when
control knob turned
to HI; noise can be
heard from spark
module.
SECTION III
Sparksare present
butnot at all
electrodes and/or
notat full strength
* Battery not installed
properly.
Dead battery.
Button assembly not
installed properly.
Faulty spark module.
oOutput lead
connections not
connected.
Output lead
connections not
connected.
" Electrical arc
between output wires
and grill frame.
Weak battery.
" Electrodes are wet.
Electrode(s) cracked
or broken; sparks
appear where
cracked.
Check battery orientation.
Has battery been used
previously?
" Check to insure threads are
properly engaged. Button
should travel up and down
without binding.
If no sparks are generated
with new battery and good
wire connections, module is
faulty.
Are output connections
on and tight?
Are output connections on
and tight?
" If possible,observegrill in
dark location.Operate
ignitionsystemand look for
arcingbetween output
wires and grill frame.
All sparks present but
weak or at slow rate.
, Hasmoistureaccumulated
on electrode and/or in
burnerports?
" Inspectelectrodesfor
cracks.
Install battery (make sure that "+" and "-"
connectors are oriented correctly, with "+" end
up and "-" end down.)
Replace battery with new AAA-size alkaline
battery.
Unscrew button cap assembly and reinstall,
making sure threads are aligned and engaged
fully.
Replace spark module assembly.
• Remove and reconnect all output
connections at module and electrodes.
Remove and reconnectall outputconnections
at moduleand electrodes.
If sparks are observed other than from
burner (s), wire insulation may be damaged.
Replace wires.
Replace battery with a new AAA-size
alkaline battery.
Use paper towel to remove moisture.
Replace cracked or broken electrodes.
23671-46477279
• 29
Advertisement
