Configuration Setting - Sena LinkIn Ride Pal III User Manual

EN
8 CONFIGURATION
SETTING
You can set the configuration of the LINKIN
Ride Pal III by the voice menu instruction
described below.
1. To enter into voice configuration menu,
press and hold the Center Button for 12
seconds until the LED shows solid blue and
you hear high toned double beeps. You will
also hear a voice prompt, "Configuration
menu".
2. Tap the (+) Button or the (-) Button to
navigate between the menus. You will
hear voice prompts for each menu item as
below.
3. You can enable/disable a feature or
execute a command by tapping the Center
Button.
22
4. If no button is pressed within 10 seconds,
the headset will exit the configuration and
go back to stand-by mode.
5. If you want to exit the configuration
immediately, Tap the (+) Button or the (-)
Button until you hear a voice prompt, "Exit
configuration", and tap the Center Button.
The voice prompt for each menu item is as
below:
(1) Phone pairing
(2) Multipoint Pairing
(3) Phone selective pairing
(4) Media selective pairing
(5) Speed dial
(6) Voice prompt
(7) Sidetone
(8) Noise control
(9) Delete all pairings
(10) Factory reset
(11) Exit configuration