Faq - Ojmar Nexo NLX1 Instruction Manual

Electronic locking system
Table of Contents

Advertisement

5.7

FAQ

QUESTION
While attempting
to initialize with
the NFC
programmer the
lock does not
respond.
The lock does not
receive the
configuration data
from the PC.
The lock does not
open.
The lock is
inoperative.
The user´s
card/wristband
does not work on
the locks.
5_MANUAL DE MANTENIMIENTO
CAUSE
The programmer is
not placed in the
correct position.
There is no
communication with
the router.
The lock is
occupied by
another key.
The lock has
detected a
definitive low-
battery (see flashes
lock).
The card/wristband
is occupied in
another lock or key
is blank.
SOLUTION
Put the programmer on the
front part as shown in the
picture.
Reset the lock by releasing the
battery holder and replace
fastening it with the two screws
(wait until the lock is calibrated,
the amber led will turn on 7
times).
Check Ethernet connection.
Make a ping to the router.
Make a ping to the PC.
Pass the master key (Red) and
check that it has released
correctly closing and opening
the lock with a free user key.
Change the batteries of the
lock and check that it is
operational by closing it and
opening it with a free user key.
Check that the card/wristband
is blank or occupied reading it
in the programmer or the
software. If it is occupied, free it
using the Management
Software or closing and
opening the occupied lock. If it
is blank, writethe
card/wristband on the
Management Software.
OJMAR 71

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Nexo NLX1 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents