Graco ProMix II Operating Manual page 21

4.
Route the opposite Fiber Optic Cable end through
the Smart Fluid Panel strain relief connector
(D). F . 15. Do not route the cable with tight bends
IG
or kinks.
The fiber optic cable has a minimum bend radius of
1.6 in. (40 mm).
B
D
F . 15
IG
5.
Connect the blue and black cable connectors (E) to
the matching connectors on the electrical circuit
board. F . 16. Insert the cable connectors until
IG
they bottom out (approximately ¼" [6 mm]), then
tighten the threaded connector.
CAUTION
Do not over-tighten or cause excessive stress on the
circuit board connector.
F . 16
IG
310633C
6.
Tighten the strain relief connector
16.
Connect Operator Station to
Smart Fluid Panel
The Operator Station cable (F) is factory wired into the
Operator Station. F
except to replace it. Route the 50 ft. (15.2 m) cable to
the Smart Fluid Panel and connect it to the Operator
Station connector
G
F
F . 17
IG
Gun Flush Box
Refer to the Gun Flush Box manual for installation and
connection instructions.
Printer
If using a printer, plug the printer cable into the
EasyKey™ Display connector
E D
F . 18
IG
Installation ◆ Cable Connections
. 17. Do not disconnect the cable
IG
(G). F . 15.
IG
(H).
(D). F .
IG
H
21