Soak Mode; Warranty; All Returns - Solid State Logic Fusion User Manual

Soak Mode

In soak mode the unit will cycle through all possible colours and modes of LEDs, to allow verification of the unit. To enter Soak
Mode, switch the unit on and hold down the INSERT and BYPASS switches during the startup LED sequence.
The HPF rotary encoder allows you to stop the cycle on an arbitrary step if set to the "OFF" position. Setting the HPF rotary encoder
to any other position will cause the cycle to run again. The higher the position, the faster the pattern will cycle through.
Press & Hold of the BYPASS switch will force the unit to reboot.

Warranty

Warranty claims will only be accepted if the purchased product has been used for its intended purpose. Any purchased product
used for an unintended purpose will not be eligible for warranty protection. For all warranty inquiries or claims please address
your claim to the dealer that you purchased the product from – or to Solid State Logic if the purchase was directly from Solid State
Logic – within a period of two months from the date on which you detected its lack of conformity with the terms of the warranty.
Please include your original proof of purchase when initiating the claim.
➤ Within the EU: Pursuant to the Solid State Logic Terms and Conditions under European consumer law the purchaser has full
statutory warranty rights for two years from the date of purchase of the product. The warranty is valid only in those Member
States of the European Union (EU) who have adopted the applicable EU law into their national legislation. The applicable
national legislation governing the sale of consumer goods is not affected by this warranty.
➤ Outside of the EU: Outside of the European Union a 12 month warranty from date of purchase is applicable.

All returns

➤ No unit will be accepted for repair by Solid State Logic unless accompanied by a valid RMA (Return Material Authorisation)
number, obtainable from Solid State Logic prior to shipping.
➤ All units should be shipped to Solid State Logic in suitable rigid packaging – Solid State Logic cannot be held responsible
for any damage caused by shipping units in other packaging.
Fusion User Guide
+ +
Troubleshooting & FAQ's
19