Unpacking; Safety Notices; Rack Mounting, Heat & Ventilation - Solid State Logic Fusion User Manual

Introduction

Unpacking

The unit has been carefully packed and inside the box you will find the following items.
➤ Fusion
➤ IEC power cord for your country
➤ Safety Sheet
➤ Quickstart Guide
➤ Registration card
It is always a good idea to save the original box and packaging, just in case you ever need to send the unit in for service.

Safety Notices

Please read the safety notice information included on the Safety Sheet inside the box before using Fusion. This information is also
available in Appendix D of this User Guide.
ATTENTION: CHECK YOUR FUSE SETTINGS
Fusion can be switched between operating with a 230V or 115V power source. Please see Appendix E: Selecting
Mains Voltage for details on how to check your fuse settings and change if necessary.
Rack Mounting, Heat & Ventilation
Fusion is a 2U, 19" rackmount piece of equipment designed to sit in the racking of a producer's desk or similar. Fusion's no
compromise design is powered by a toroidal transformer and as such, the left-hand side of the unit can become warm to the
touch. It is recommended that ventilation space is left above and below the unit. If this is not possible, then it is recommended
Fusion be placed at the top of the rack, so any heat generated by Fusion rises away from surrounding equipment. The sides of
the Fusion chassis have cut-outs that should under no circumstances be blocked or covered. Always allow Fusion to cool down
before handling.
2
Fusion User Guide