Factory Reset; Simon Says Game - Solid State Logic Fusion User Manual

Factory Reset

To reset Fusion to factory settings, switch the unit on then hold down the VINTAGE DRIVE IN and BYPASS switches during the
startup LED sequence.
Factory Reset allows reset of any stored settings (Brightness, Relay feedback, BYPASS and INSERT configurations) to the factory
default. Press and hold the combination of switches until all the switches start flashing. After releasing the switches, the unit will
automatically reboot and the factory settings will be restored.

Simon Says Game

To play the Simon Says game, switch the unit on and hold down all four IN switches during the startup LED sequence.
The BYPASS switch will flash red. The highest score achieved on the unit is shown on the master meters; the right bar meter is
points x1, the left bar meter is points x10 (e.g. two LEDs lit on the left and six LEDs lit on the right means that the current highest
score is 26). If the maximum score is reached, the two top red LEDs are lit. Factory reset does not affect the highest score for the
unit.
1. Press the flashing BYPASS switch to start a round.
2. A random switch between the first four switches will light up briefly (The relay will also click a number of times equal to the
position of the switch; switch 1 = 1 click, switch 2 lit = 2 clicks etc).
3. The aim of the game is to press the correct switch within four seconds. If the wrong switch is pressed or a timeout of four
seconds elapses, the game resets.
4. If you press the correct switch, you move to the next level and another switch is added to the sequence.
Note: Every three levels the difficulty increases by displaying the sequence faster.
To exit this mode, simply power -cycle the unit.
Fusion User Guide
+
VINTAGE DRIVE
1
+ +
VINTAGE DRIVE
+
2
+
VIOLET EQ HF COMPRESSOR
Settings Mode & Factory Reset
3 4
+
STEREO WIDTH
17