Appendix D - Safety Notices; General Safety; Installation Notes; Power Safety - Solid State Logic Fusion User Manual

Appendix D

Appendix D - Safety Notices

General Safety

Read these instructions.
-
Keep these instructions.
-
Heed all warnings.
-
Follow all instructions.
-
Do not use this apparatus near water.
-
Clean only with dry cloth.
-
Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
-
Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that
-
produce heat.
Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider
-
than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are
provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the
obsolete outlet.
- Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
Only use attachments/accessories recommended by the manufacturer.
-
Unplug this apparatus during lightning storms or when unused for long periods of time.
-
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any
-
way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
Do NOT modify this unit, alterations may affect performance, safety and/or international compliance standards.
-
SSL does not accept liability for damage caused by maintenance, repair or modification by unauthorised personnel.
-

Installation Notes

- When installing this apparatus either fix it into a standard 19" rack or place it on a secure level surface.
If the unit is rack mounted, fit all rack screws. Rack shelves are recommended.
-
When rack mounting allow a 1U gap above and below the unit for cooling.
-
Ensure that no strain is placed on any cables connected to this apparatus. Ensure that all such cables are not placed where
-
they can be stepped on, pulled or tripped over.
WARNING: To reduce the risk of fire or electric shock do not expose this apparatus to rain or moisture.
ATTENTION: Afin de réduire les risques de choc électrique, ne pas exposer cet appareil à l'humidité ou à la pluie.

Power Safety

The unit is not supplied with a mains lead allowing you to use IEC distribution of mains cables of your choice. Any mains
-
cable used must fulfill the following:
Refer to the rating label on rear of the unit and always use suitable mains cords.
-
The unit should ALWAYS be earthed with the earth on both the IEC sockets (when both are used).
-
Please use-compliant 60320 C13 TYPE SOCKET. When connecting to supply outlets ensure that appropriate sized
-
conductors and plugs are used to suit local electrical requirements.
- Maximum cord length should be 4.5m(15').
The cord should bear the approval mark of the country in which it is to be used.
-
Connect only to an AC power source that contains a protective earthing (PE) conductor.
-
Only connect units to single phase supplies with the neutral conductor at earth potential.
-
24
Fusion User Guide