Changing The Fuse From 230V To 115V - Solid State Logic Fusion User Manual

Appendix E

Changing the fuse from 230V to 115V

1.
2.
3. Remove the fuse cartridge, then remove the small metal link plate. Place the link plate on the opposite side of the fuse
cartridge (you will need to remove the fuse to do this).
4. Place the new fuse in the vacant slot on the opposite side of the fuse cartridge.
5. Re-orientate the fuse cartridge 180 degrees and reposition it so that the alternate operating voltage value is displayed
through the slot in the fastening. Re-seal the fastening, reconnect the IEC power cable, and switch the unit on.
28
Remove the IEC power cable from the IEC socket.
Remove the fastening by leveraging a flat-head screwdriver in the slot at the top of the fuse panel.
Fusion User Guide