Epson TM-L60II Technical Information page 161

C O N F I D E N T I A L
TM-U300A/B:
[Default]
None
[Printers not featuring this command]
[Description]
Defines user-defined characters from character code check c1 to c2.
• y specifies the number of bytes in the vertical direction.
• x specifies the number of dots in the horizontal direction.
• d is the dot data for the user-defined characters.
[Notes] Character codes from the alphanumeric characters (20H (decimal 32) to 7EH (decimal 126))
can be defined.
Data (d) specifies a bit printed to 1 and not printed to 0. The dot pattern is in the
horizontal direction from the left side. Any remaining dots on the right side are blank.
The data to define a user-defined character is (y × x) bytes.
When the value of y, c1, c2, or x is out of the range, this command is canceled, and the
following data is processed as normal data.
This command can define user-defined characters for each font independently. To select a
font, use ESC ! or ESC M.
A user-defined character and downloaded bit image cannot be defined simultaneously.
When this command is executed, the downloaded bit image is cleared.
Paper roll Character commands
y = 2
32 ≤ c1 ≤ c2 ≤ 126
0 ≤ x ≤ 12 (Font A (9 × 9))
0 ≤ x ≤ 10 (Font B (7 × 9))
0 ≤ d ≤ 255
k = c2 - c1 + 1
None
ESC &
Ver. 4.0
p. 1098
more
more