Using The Wavevision4 Software With The Adc081500Dev; Getting Started - National Semiconductor ADC081500DEV Instruction Manual

9.0 Using the Wavevision4 software with the ADC081500DEV

IMPORTANT NOTE: Before connecting this board to the PC, please install the Wavevision 4
Software from the CDROM included with the development kit. (See Appendix B)
Connecting the Development Board before installation may result in the board being registered as
an unknown USB device. If this happens you will need to uninstall the device using the Windows
Device Manager before installing the Wavevision 4 Software.

9.1 Getting Started

This development board is designed to connect over a USB interface to a PC running the Wavevision 4
Software.
Ensure the board is connected to the 12V power supply (included in the package) and that the switch on
the rear panel is pushed to the "ON" position. The Green LED on the rear panel should be illuminated
Connect the USB cable between the PC which has Wavevision 4 software installed and the
ADC081500DEV board. The USB port can also be found on the rear panel (shown below).
st
If this is the 1 time the board has been connected to the PC, Drivers may be required to be installed
(automatic) by the Operating System. Follow the on screen instructions and use the recommended
settings.
Start the Wavevision 4 software (Start -> All Programs -> Wavevision -> Wavevision 4)
The software may take several seconds to initialize, but should display a welcome screen similar to the
following.
15 www.national.com