Drive Status Indicators & Dpi Port Locations - Allen-Bradley PowerFlex 700 Installation Instructions Manual

PowerFlex 700 Adjustable Frequency AC Drive – Frames 7...10
68
Drive Status Indicators & DPI Port Locations
PORT
MOD
NET A
NET B
No. Name Color State
PWR Green Steady
(Power)
STS Green Flashing
(Status)
Steady
Yellow Flashing, Drive Stopped
Flashing, Drive Running An intermittent type 1 alarm condition is occurring.
Steady, Drive Running
Red Flashing
Steady
PORT Refer to the Communication
Adapter User Manual.
MOD
NET A
NET B
DPI Port 1
DPI Port 5
DPI Port 3 or 2
DPI Port 2
Rockwell Automation Publication 20B-IN014H-EN-P - June 2013
Important:
Verify metal
ground tab is
bent 90° and is
under the adapter before
tightening screw. After
tightening the screw, verify
TB11
25 AMPERES RMS
MAXIMUM
that continuity exists
between the head of the
screw and drive ground.
Description
Illuminates when power is applied to the drive.
Drive ready, but not running and no faults are present.
Drive running, no faults are present.
A start inhibit condition exists, the drive cannot be started.
Check parameter 214 [Start Inhibits].
Check parameter 211 [Drive Alarm 1].
A continuous type 1 alarm condition exists.
Check parameter 211 [Drive Alarm 1].
Fault has occurred. Check [Fault x Code] or Fault Queue.
A non-resettable fault has occurred.
Status of DPI port internal communications (if present).
Status of communications module (when installed).
Status of network (if connected).
Status of secondary network (if connected).
HIM connection.
Cable connection for communications adapter.
Splitter cable connected to DPI Port 2 provides additional port.
Cable connection for handheld and remote options. Located
on side of chassis for Frame 7 IP20, NEMA/UL Type 1.
TE