Accessories Parts List - DoorKing 1603 Installation & Owner's Manual

9.4 Accessories Parts List

The following accessories are available for the 1603 barrier gate operator.
Plug-In Loop Detector - Plug directly into ports on circuit board simplifying wiring.
P/N 9410-010 - Single channel detector.
P/N 9409-010 - Two channel detector.
P/N 9411-010 - Single channel detector with aux relay. Controls arm lowering for vehicles but NOT for pedestrians.
P/N 9416-010 - Single channel low power draw detector
P/N 9415-010 - Dual channel low power draw detector
Loop Wire - XLPE insulation is available in 500 and 1000 foot rolls, available in Black, Blue and Red insulation.
Loop Sealant - P/N 2600-771 Asphalt, P/N 2600-772 Concrete
Meg Ohm Meter - Checks the integrity of ground loops. P/N 9401-045
Reverse Edge - Installs on the bottom of the aluminum arm. P/N 8080-016 - 6 ft. Available from DoorKing to fit all arm lengths.
Photo Cell - Prevents arm from lowering on vehicles or pedestrians. P/N 8080-018
Time Clock - 7 clock, used to automatically open gate at pre-set time, fits inside operator.
P/N 2600-791 - 7 day clock
Surge Devices - Helps prevent circuit board failure caused by lightning strikes and power surges.
P/N 1879-080 - High Voltage
P/N 1878-010 - Low Voltage
Replacement Battery - Convenience open system. P/N 1801-009 (2 required)
Speed Bump - Prefabricated 6-foot speed bump reduces traffic speed through gate system. P/N 1610-150
Heater Kit - Thermostatically controlled heater for cold weather areas. 115 VAC - P/N 1601-092
Fan Kit - Thermostatically controlled fan for hot humid environments. P/N 1601-093
Manual Gate Control Toggle
Interconnection Cable - Interconnection cable contains all the necessary wires to interconnect primary / secondary operators.
Cable length: 30 ft. - P/N 2600-755
High Voltage Kit - Alter the input AC voltage on a 115 VAC 1603 to 208, 230, 460 or 575 VAC. P/N 2600-266
Gate Tracker™ - Optional control board allows the barrier gate operator to report activity to a companion 1833, 1835, 1837 or
1838 access control system.
Auto Spike System Parts
Operator Extension Section - 1.5 Ft torsion shaft, tunnel plate and ramp. P/N 1603-168
Extension Section - 1.5 Ft extension shaft, tunnel plate and ramp. P/N 1603-170
Spike Section - 3 Ft spike shaft, tunnel plate and ramp. P/N 1603-165
End Cap - P/N 1610-240
Aluminum Arm Only - 14-foot replacement aluminum arm. P/N 1601-571
Aluminum Folding Arm Kit
Aluminum Arm Mounting Kit
Arm Padding - Foam padding for the aluminum or wood arm. P/N 1601-211
Lighted Auto Spike Warning Sign
Traffic Light (Red, Green)
32
- Allows user to manually operate gate arm. Fits inside single-gang electrical box. P/N 1200-017
40 ft. - P/N 2600-756
- Low headroom applications (Arm included). P/N 1601-610
- Aluminum mounting bracket, hub and mounting hardware. P/N 1601-242
- Backlit spike warning sign with adjustable light for spike illumination. P/N 1615-081
- Manage the traffic flow with red-green lights. Bolts onto the 1603 operator. P/N 1603-210
50 ft. - P/N 2600-757
1603-065-F-8-18