Dump Protocols Dot1X - Alaxala AX6700S Software Manual

dump protocols dot1x

Outputs control table information and statistics collected by the IEEE 802.1X program to a file.
Syntax
dump protocols dot1x
Input mode
User mode and administrator mode
Parameters
None
Example
Figure 5-23: Acquiring IEEE 802.1X program online dump
> dump protocols dot1x
>
Display items
None
Impact on communication
None
Response messages
Table 5-9: List of response messages for the dump protocols dot1x command
Message
Can't execute this command in
standby system.
Can't execute.
Connection failed to 802.1X
program.(Reason:Connection
Error)
Connection failed to 802.1X
program.(Reason:Receive Error)
Connection failed to 802.1X
program.(Reason:Send Error)
Dot1x doesn't seem to be running.
Now another user is using dot1x
command, please try again.
Notes
The storage directory and the name of the dump file are as follows:
Storage directory:
Dump file:
If necessary, back up the file in advance because the specified file is unconditionally overwritten
if it already exists.
This command cannot be executed on a standby system.
The command could not be executed. Re-execute the command.
An attempt to connect to the IEEE 802.1X program failed. Re-execute the command.
If the failure occurs frequently, use the
802.1X.
An attempt to receive data from the IEEE 802.1X program failed. Re-execute the
command. If the failure occurs frequently, use the
restart IEEE 802.1X.
An attempt to send data to the IEEE 802.1X program failed. Re-execute the command.
If the failure occurs frequently, use the
802.1X.
The IEEE 802.1X setting has not been enabled. Check the configuration.
Another user is using the
/usr/var/dot1x
dot1x_dump.gz
Description
restart dot1x
restart dot1x
restart dot1x
command. Wait a while, and then retry the operation.
dot1x
5. IEEE802.1X
command to restart IEEE
command to
command to restart IEEE
121