Installation - Wells HSW6DAF Operation Manual

INSTALLATION

NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
Fig. 2 Set the Wellsloks
IMPORTANT:
Water damage caused by
failure to seat Wellsloks or
failure to install gasket or to
seal flange to counter is NOT
covered by warranty
UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all
protective plastic film, packing materials and accessories from the
appliance before connecting electrical power or otherwise performing
any installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the appliance before starting any
installation.
Read and understand all labels and diagrams attached to the
appliance.
Carefully account for all components and accessories before
discarding packing materials. Store all accessories in a convenient
place for later use.
PREPARATION
Carefully read the Installation Instruction Sheet packed with the
appliance for cutout dimensions and restrictions.
For both wood and non-combustible (i.e. metal) installation, do not
install closer than 4-1/2" to front wall unless the control unit is placed
beneath the warmer unit, in which case clearance to front wall may
be 1". Also, do not install closer than 1" to back wall, 2" to side walls,
or 6-3/4" to surface below unit.
Supplied gasket must be installed under the mounting flange, and the
Wellsloks turned out to seal the appliance and control unit to the
counter.
Apply a thin bead of food-grade silicone sealant where the flange
meets the counter.
4