Page 1
Additional manuals are available from your WELLS DEALER. THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any questions concerning installation, operation or maintenance of this equipment.
Page 2
(775) 689-5707 or fax (775) 689-5976 if service is performed by unauthorized personnel. The prices charged by Wells Bloomfield for its products are for information and other details concerning warranty. SERVICE POLICY AND PROCEDURE GUIDE and ADDITIONAL WARRANTY EXCLUSIONS Resetting of safety thermostats, circuit breakers, over cleaning schedules, are customer responsibility.
PARTS & SERVICE CUSTOMER SERVICE DATA INTRODUCTION Thank You for purchasing this Wells Bloomfield appliance. Proper installation, professional operation and consistent maintenance of this appliance will ensure that it gives you the very best performance and a long, economical service life.
Power is controlled by the front panel ON/OFF SWITCH. IMPORTANT: Temperature is controlled by a thermostat is factory set for Temperature adjustment on 135ºF. model 6411S must be NOTE: performed by a qualified The setpoint temperature may be adjusted by removing technician.
Damage Do not operate this appliance if the control panel is damaged. Call to the appliance may result if your Authorized Wells Service Agent for service. these instructions are not followed. The technical content of this manual, including any wiring diagrams, schematics, parts breakdown illustrations and/or adjustment procedures, is intended for use by qualified technical personnel.
INSTALLATION NOTE: DO NOT discard UNPACKING & INSPECTION the carton or other packing Carefully remove the appliance from the carton. Remove all materials until you have protective plastic film, packing materials and accessories from the inspected the appliance for Appliance before connecting electrical power or otherwise performing hidden damage and tested it any installation procedure.
Wells Manufacturing recommends operating WET for consistent food heating. d. If your wet-operation Soup Cookers or Food Cooker is allowed to run dry, turn it OFF and allow to cool to room Always use an inset.
Page 8
DO NOT splash or pour water Be sure to keep the warmer covered during preheat and onto control panel or wiring. operation. 6411S: Always use an inset. Press power switch to "ON". Allow warmer to preheat for DO NOT place food directly recommended time before adding food product (see chart below).
Contact your Authorized Wells Service Agency to inspect the warmer if you suspect water or grease contamination. Add proper amount of warm water. Reconnect warmer to electric power.
CARE OF ANODIZED ALUMINUM (SC-7 & SC-11) The well in your Wells Warmer or Soup Cooker is constructed of high quality anodized aluminum. As long as the anodized surface layer is intact, the equipment will not corrode. The anodized surface can be damaged by mechanical abrasion, hard water deposits and chlorine: 1.
Page 11
Never use metal implements, wire brushes, abrasive scratch pads or steel wool to clean stainless steel. Warmer pans, insets and other vessels are subject to a harsher environment. Wells Manufac- turing uses an very high quality stainless steel (#304DDQ) for our food warmer pans. Even the...
Remove water from pan until no Too much water in well more than 1” of water remains in well There are no user-serviceable components in this appliance. In all instances of damage or malfunction, contact your Authorized Wells Service Agency for repairs.
(775) 689-5976 11 QT. ROUND INSET w/ hinged lid 21057 Service Parts Department can ADAPTER TOPS FOR Deluxe, SC-11 and 6411S supply you with the name and telephone number of the ONE 7 QT. INSET ADAPTER TOP 20175 WELLS AUTHORIZED SERVICE AGENCY ONE 4 QT.
Page 14
Commercial Food Equipment Service Association Wells Bloomfield proudly supports CFESA Commercial Food Equipment Service Association SERVICE TRAINING - QUALITY SERVICE SERVICE TRAINING - QUALITY SERVICE Genuine Parts Protect - YOU - All - Ways CUSTOMER SATISFACTION CUSTOMER SATISFACTION WELLS BLOOMFIELD, LLC 2 ERIK CIRCLE, P.
Need help?
Do you have a question about the 6411S and is the answer not in the manual?
Questions and answers