Installation - Wells SS206 Owner's Manual

NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
WARNING:
RISK OF INJURY
Installation procedures must
be performed by a qualified
technician with full knowledge
of all applicable electrical and
plumbing codes. Failure can
result in personal injury and
property damage.
CAUTION
FIRE HAZARD
Avoid storing flammable or
combustible materials in, on
or near the appliance.
IMPORTANT: For warmers
installed in plastic counter
tops, the counter material
must be protected from the
heat of the warmer in order to
prevent discoloration and/or
deterioration. Wellsloks are
not suitable for this purpose.
The installer should contact
the manufacturer or distributor
of the countertop material for
specific instructions.

INSTALLATION

UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all
protective plastic film, packing materials and accessories from the
Appliance before connecting electrical power or otherwise performing
any installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the appliance before starting any
installation.
Read and understand all labels and diagrams attached to the
appliance.
Carefully account for all components and accessories before
discarding packing materials. Store all accessories in a convenient
place for later use.
INSTALLATION NOTES
1.
Installation and start up of built-in warmers MUST be performed
by an authorized installation company.
2.
It is the RESPONSIBILITY OF THE INSTALLER to verify that this
warmer installation is in
listed in this manual and on the specification sheet provided.
3.
It is the RESPONSIBILITY OF THE INSTALLER to check with
the AUTHORITY HAVING JURISDICTION, in order to verify that
this warmer installation is in compliance with local code require-
ments.
4.
Water supply and drain installation must meet all applicable lo-
cal, state and federal plumbing codes and ordinances.
5.
Refer to Installation Instructions included with the warmer for
Underwriters Laboratories conditions of acceptability, electrical
requirements and other installation con-
cerns.
BUILT-IN WARMERS
1.
This is a GENERAL GUIDE. For specific
cutout dimensions and other installation
details, refer to theInstallation Instructions
supplied with the warmer.
2.
Cutout dimensions for warmer units and
control panels are listed on the Installation
Instructions provided with the
warmer.
3.
SS206 units use an oval control panel to
mount the infinite switch.
SS206E and SS206ER units mount the
infinite switch directly to the cabinet face.
Verify style of control mounting before
making cutout.
NOTE: Cutout dimensions are different for
oval control panels and direct mounting, and for wood and metal
counters. Verify the dimensions are correct for the installation
before making the cutout.
6
compliance with the specifications
OVAL CONTROL PANEL
DIRECT MOUNT