Ultimate Healthcare Cura II User Manual page 28

13.8 Mesh full length side rail bumper
The fitting instructions are for the installation of UBEB002001FL-2MESH designed to fit to the
telescopic full length extending side rails. The mesh side rail bumpers have been specifically
designed for the Cura Community, Cura II and Cura II Supreme beds.
1. Remove bed rail bumpers from the packaging and dispose of the packaging safely.
2. Locate the velcro and make sure it is facing towards the outside of the side rail.
3. Join velcro strips A and A together over the top side rail and attach along their entire
length.
4. Follow step 3 for velcro strips B and B on the bottom rail.
5. Ensure that the side rail bumper is securely fixed before use.
6. Periodically check to ensure that the bumper is securely attached to the bed rail.
13.9 Attaching mesh full length side rail extension bumpers
7. To add the mesh full length side rail bumper extension, extend the
bed and telescopic full length side rail.
8. Join velcro strips A and A together over the top side rail and attach
along their entire length and do the same for velcro strips B and B on
the bottom rail.
9. Make sure the extension bumper is placed over the section where
the bed extends.
Issue: 6: 08/11/2018
DRAFT
Page 28 of 40