Cpu: System - Delta Electronics AH500 Operation Manual

Hide thumbs Also See for AH500:

Table of Contents

A H 5 0 0 O p e r a t i o n M a n u a l

CPU: System

After users click the CPU tab at the top of the window, and the System tab at the bottom of the window, they

can set the parameters in the CPU module.

Clear Non-latched Device (STOPRUN)

If the Enable checkbox is selected, the states of the non-latched devices, and the values in the

non-latched devices are cleared when the CPU module begins to run.

Y state (STOPRUN)

When the CPU module begins to run, the states of the Y devices are OFF, retained, or restored to the

states before the CPU module's stopping running.

 Clear: All Y devices are set to OFF.

 Retain Present State: The states of the Y devices are retained.

 Previous State before STOP: The states of the Y devices are restored to the states before the CPU

module's stopping running.

Reset Button & Clear Button

Whether the RST button and CLR button on the CPU module is enabled or disabled depends on the

setting of these parameters. Please refer to an operation manual for more information about the functions

of the buttons.

Table of Contents