Procedure For Creating A Project In Ispsoft; Creating A Project - Delta Electronics AH500 Operation Manual

6.2 Procedure for Creating a Project in ISPSoft

The procedure for creating a project in ISPSoft is as follow. Users can adjust the procedure according to the
practical application and their habits.

Hardware configuration
Users can set the parameters such as a range of latched devices and a port number in a PLC. Besides,
the users have to configure modules used with an AH500 series CPU module, and set the parameters in
these modules.

Network configuration
If a system used adopts network architecture, or devices need to exchange data, users can configure a
network, a PLC Link, or an Ether Link easily through the network configuration tool NWCONFIG in ISPSoft.

Programming
After users write a program in ISPSoft, they can compile the program. If the compiling of a program is
unsuccessful, the messages in the Compile Message page can lead users to the places where errors
occur to check the program code.

Test and debugging
Users can download a program which is compiled, a hardware configuration, and a network configuration
to a PLC. Besides, the users can test and debug the program online by means of the functions provided by
ISPSoft.
Owing to the fact that the example introduced in this chapter does not discuss a network configuration, only the
following procedure is carried out. The procedure will be introduced in the following section.

6.3 Creating a Project

After ISPSoft is started, users can click the File menu, point to New, and click New to create a new project.
They can also create a new project by clicking
C h a p t e r 6 W r i t i n g a P r o g r a m
on the toolbar after ISPSoft is started.
6 - 3