5-12
Stop <CR>
getLevel2CompassCalibration
13. At this point, the SSAHRS calibration is complete. Close out of remote desktop.
5.4.1 Changing the Angle of Declination
The compass' angle of declination is set to true north at the EdgeTech facility. However, to provide a more
accurate target location, it is necessary to enter the known magnetic declination for the survey location
into the compass as follows:
1. Repeat steps 1 through 6 in Calibration procedure in section 5.4.
2. Verify current Declination Angle of Deviation using the following command:
getDeclination <CR>
2000-CSS COMBINED SONAR
Figure 5-17
5.0: MAINTENANCE
0017423_REV_C