Time And Location; Sntp; Server Ip Address; Polling Interval - Harris RF-7800W-OU470 Installation & Operation Manual

RF-7800W
SYSTEM ADMINISTRATION AND CONFIGURATION
3.7

TIME AND LOCATION

The radio has some time and location options available that can help with system troubleshooting and maintenance.
See Figure 3-4.
3.7.1

SNTP

The subsections below describe Simple Network Time Protocol (SNTP) configuration parameters. All parameters
for SNTP can be accessed using GUI, CLI, and SNMP interfaces.
3.7.1.1

Server IP Address

This is the IP address of a valid SNTP server that the radio can use to determine the current time.
3.7.1.2

Polling Interval

This interval defines the period of time between polls to the SNTP server for time. Periodic polling is required to
synchronize time with other network devices. The radio can be directed to poll the SNTP server on demand using
SNMP.
3.7.1.3

Time Zone (GMT)

This defines how much offset is applied to time that is received by the SNTP service. This should be set to the time
zone where the radio is located in order to provide an accurate time.
3.7.2

GPS

The subsections below describe Global Positioning System (GPS) configuration parameters. All parameters for GPS
can be accessed using GUI, CLI, and SNMP interfaces.
3-14
Figure 3-9. FIPS Status
GUI CLI SNMP
GUI CLI SNMP
R