Configure The Subscriber Stations; Configure The Sector Controller; Log In - Harris RF-7800W-OU470 Installation & Operation Manual

R
b. Connect an Ethernet cable between the IN port on the PoE injector and computer.
c. Configure the computer's IP address so that it is different than the radio's default IP address
(192.168.26.2), but also on the same subnet (255.255.255.0). The address should be in the range
192.168.26.1 - 192.168.26.254.
d. Open a web browser to the radio's address and log in using the default credentials (admin/admin).
See Figure 2-1.
2.3.2

Configure the Subscriber Stations

a. Select System Configuration, change the IP Address from the default to a unique value, and select
Apply & Save All. This ensures that each radio can be properly accessed once wireless Links establish.
See Figure 3-4.
b. Reconfigure the computer's IP Address if necessary (e.g. if the radio IP Address was set outside of the
range 192.168.26.1-192.168.26.254).
c. Open a web browser to the radio's new address and log in.
d. Select Wireless Configuration, configure the Frequency and Channel Size based on frequency
availability, and select Apply & Save All. These settings must be the same for all radios that are to be
linked. See
e. Change the Tx Power, if necessary, and select Apply & Save All.
f. Perform the System and Wireless Configuration for all other SS radios, recording each radio's MAC
address if using Normal Links as they will be needed when configuring the SC radio. Otherwise, ensure
that the STID and STID Password match those of the SC radio if using Link templates.
2.3.3

Configure the Sector Controller

a. Select System Configuration, change the IP Address from the default to a unique value, and select
Apply & Save All. This ensures that each radio can be properly accessed once wireless Links
establish.See
b. Reconfigure the computer's IP Address if necessary (e.g. if the radio IP Address was set outside of the
range 192.168.26.1-192.168.26.254).
c. Open a web browser to the radio's new address and log in.
d. Select Wireless Configuration and change the System Mode to SPMP SC. See
Figure 2-1. Log In
Figure 3-16.
STID Password defaults to "default".
Figure 3-4.
NOTE
RF-7800W
SYSTEM INSTALLATION
Figure 3-14.
2-3