Ip Management Interface Parameters; Console Port Settings; Factory Default Login Credentials - Harris RF-7800W-OU470 Installation & Operation Manual

RF-7800W
SYSTEM ADMINISTRATION AND CONFIGURATION
Default values of IP management interfaces are shown in
* In addition to the default static IP Address, the radio uses ZeroConf technologies to automatically self-assign a
second unique IP Address and a hostname and to advertise the presence of its management interfaces (HTTP and
SSH). The ZeroConf services are intended solely to ease initial configuration and are disabled once an operator
configures a new static IP Address.
The Console data port interface uses RS-422 with port settings as shown in
The factory default login credentials are shown in
changing the configuration of the radio. The "User" user group has access to less configuration permissions, but is
simpler to use. The "Monitor" user group is meant to be used by machine interfaces that only need read access to
small set of commands.
admin
user
monitor
Changes to the radio's configuration are not applied until an "apply" or "save" command is issued in any of the
management interfaces. Even after applying the changes to the active configuration, the changes must be saved to
the on-board memory by issuing a "save" command. If the configuration is applied but not saved, a power loss or
an intentional reboot will cause any changes made since the last "save" to be lost.
3-2
Table 3-1. IP Management Interface Parameters
Parameter
IP Address
HTTP
HTTPS
Telnet
SSH
SNMP
Table 3-2. Console Port Settings
Port Parameter
Speed (baud rate)
Data Bits
Stop Bits
Parity
Flow Control
Table 3-3. Factory Default Login Credentials
User Name
Table 3-1.
Default Value
192.168.26.2*
Enabled
Enabled
Enabled
Enabled
None
Value
115200
8
1
None
None
Table 3-3. The "Admin" user group is meant to be used for
Password
admin
user
monitor
Table 3-2.
User Group
admin
user
monitor
R