SATO M-84PRO Operation Manual page 28

Operation Manual
Label Sensor Selection (DSW3-3). Enables or disables the Label Sensor. If the
Sensor is enabled, it will detect the edge of the label and position it automatically. If it
is disabled, the positioning must be under software control using Line Feed
commands.
DSW3-3
Off
On
Back-Feed Selection (DSW3-4). When Back-Feed is enabled, the printer will
position the last printed label for dispensing and retract it before printing the next
label. The amount of backfeed offset is adjustable.
DSW3-4
Off
On
External Signal Interface. See Section 6: Interface Specifications for information
on the External Signals.
EXT Print Start Signal Selection (DSW3-5). Allows an external device to initiate a
label print for synchronization with the applicator. When DSW3-5 is On, the unit is in
the Continuous print mode, Backfeed is disabled and External Signals are ignored.
DSW3-5
Off
On
SATO M-84PRO
SETTING
Not Used
Sensor Used
SETTING
Disabled
Enabled
SETTING
Enabled
Disabled
Section 3. Configuration
DSW3
ON
OFF
1 2 3 4 5
DSW3
ON
OFF
1 2 3 4 5
DSW3
ON
OFF
1 2 3 4 5
6 7 8
6 7 8
6 7 8
Page 3-5