SATO M-84PRO Operation Manual page 17

Operation Manual
Inside Label Edge Guides
11. Adjust the outside Label Edge Guide until it
touches the outside edge of the label and
tighten the thumb screw. Make sure the
labels are also touching the inside edge
guides.
CAUTION: Using media narrower than the
maximum print width may cause excess
head wear due to the label edge. See page
2-9 for precautions.
12. If the ribbon is already loaded, close the Print
Head by rotating the black Head Latch
toward the front of the printer until it latches
closed.
13. If the ribbon is not loaded, see the following description for loading instructions.
14. Close both the Access Doors.
SATO M-84PRO
Label Hold Down
Sensor
Sensor
Assembly
Positioning
Section 2. Installation
Route Labels
Under Guide
Head
Latch
Page 2-5