SATO M-84PRO Operation Manual page 27

Section 3. Configuration
Firmware Download (DSW2-6). Places the printer in the Firmware Download mode
for downloading new firmware into flash ROM.
DSW2-6
Off
On
Protocol Code Selection (DSW2-7). Selects the command codes used for
protocol control. Refer to page E-1 for more information.
DSW2-7
Off
On
Status Select(DSW2-8). For emulating earlier series software commands. Should
be used only if problems are encountered when using existing software. This switch
will also affect the settings selected by DSW1-7 and DSW1-8.
DSW2-8
Off
On
Backfeed Sequence (DSW3-1, DSW3-2). Backfeed is used to correctly position
the label for application and then retract the next label to the proper print position.
This operation can be performed immediately after a label is printed and used, or
immediately prior to the printing of the next label.
DSW3-1
Off
Off
On
On
* Defaults to Continuous if cutter not
installed
Page 3-4
SETTING
Disabled
Enabled
SETTING
Standard
Non-Std
SETTING
Status 3 & 4 Enabled
Status 2 & 3 Enabled
SETTING
Off Continuous
On Tear-Off
Off Cutter*
On Not Used
Operation Manual
DSW2
ON
OFF
1 2 3 4 5
DSW2
ON
OFF
1 2 3 4 5
DSW2
ON
OFF
1 2 3 4 5
DSW3
ON
OFF
1 2 3 4 5
6 7 8
6 7 8
6 7 8
6 7 8
SATO M-84PRO