Cornelius PRISM Owner's Manual page 15

4. Align the 2 dowel pins of the "Rear
Die" with Corresponding holes on
the "Valve mounting panel".
5. Assemble "Front Die" loaded with
"Punch Tool" to "Rear Die", using 2
Phillip "8-32" screws.
6. Assemble & tighten the hexagon
bolt using socket wrench, until the
bolt head rests on the front die sur-
face.
NOTE: Add lubricant to 3/16" bolt
before using the knockout.
7. Remove the tool from the valve
mounting panel and dispose of the
punched out piece.
!
CAUTION:
NOTE: Position of the punching may vary, depending upon requirement.
NOTE: With reference to Step - 5, all 2 screws must be tightened to avoid any tool damage or improper
punching.
© 2018, Cornelius Inc.
Figure 15.
Figure 16.
Figure 17.
Figure 18.
- 11 -
Prism Owner's Manual
Valve
Mounting
Panel
Rear Die
Publication Number: 548000096