Knock Out Punch Instructions - Cornelius PRISM Owner's Manual

Prism Owner's Manual
K O P
NOCK UT UNCH
!
WARNING:
Must wear required PPE and right tools before using the punch out tool.
!
WARNING:
Disconnect power to the unit before servicing following all lock out/tag out procedures established by the user.
Verify all of the power is off to the unit before any work is performed.
!
CAUTION:
Disconnect all fluid supply to the unit and release all pressures in the system.
1. Remove the valve from the back
block.
2. Remove the existing back-block
from the valve panel.
NOTE: Keep the screws safe for
later.
NOTE: used with installation of new
"Prism".
3. Load the "Front Die" with "Punch
Tool".
Publication Number: 548000096
I
NSTRUCTIONS
Table 3 .
- 10 -
Figure 12.
Figure 13.
Front Die
Punch Tool
Figure 14.
© 2018, Cornelius Inc.