Safety; Directives; General Safety Instructions - Pfaff 3819 series Instruction Manual

1

Safety

1

Directives

.01
The machine was built in compliance with the European regulations specifi ed in the declara-
tion of conformity and declaration of incorporation.
As a supplement to this instruction manual, please also observe the generally applicable,
legal and other regulations and legislation – also in the country of use – and the valid
environmental protection regulations! Always comply with the locally applicable regulations
of the professional associations and other supervisory authorities!
1

General safety instructions

.02
 The machine may only be operated after you have become acquainted with the associ-
 Always read the safety instructions and the instruction manual of the motor manufactur-
 Always follow the hazard and safety instructions attached to the machine!
 The machine may only be operated for its intended purpose and only with the associated
 The machine must always be disconnected from the power supply by pressing the main
 The daily maintenance work may only be carried out by suitably qualifi ed personnel!
 Repairs and special maintenance work may only be carried out by technical staff or peo-
 Unless otherwise stated, the machine must be isolated from the power supply and pneu-
 Work on electrical equipment may only be carried out by qualifi ed technical staff!
 Work on parts and equipment under voltage is not permitted!
 Modifi cations and changes to the machine may only be made in compliance with all of
 Only replacement parts approved by us for usage may be used for repairs! We warn you
ated instruction manual and only by operating personnel who have received appropriate
training!
er before starting up the machine!
safety covers, while adhering to all the relevant safety requirements.
switch or pulling out the mains plug when sewing tools are replaced (such as the needle,
sewing foot, needle plate, feed dog etc.) and when threading, leaving the workstation, or
performing maintenance!
ple with appropriate training!
matic supplies before any servicing work or repairs are performed! The only permitted
exceptions
are for adjustment work and functional tests by appropriately trained
technical staff!
Exceptions are regulated by the EN 50110 standards.
the relevant safety requirements!
expressly that spare parts and accessories that are not supplied by us are also not tested
and approved by us.
Fitting or using these products may therefore have negative effects on features which
depend on the machine design. We are not liable for any damage caused by the use of
non-Pfaff parts.
Safety
5