Location 4 Events To Report To Email; Location 5 Special Events To Report To Email; Location 6 Events To Report To - GE NX-591E Installation And Startup Manual

Location 4
(Phone fault detected) 16 segments of Feature Selection Data
Reporting must be enabled in the control panel for this location to function
properly.
This location selects the partition(s) to include when reporting to email. To exclude any partition from
reporting, simply turn off the LED corresponding to that particular partition. Using Table XI-1 on page
12, enter the corresponding number of the partition(s) to include for each type of report found in
Segments 1 –16. Factory default is all partitions OFF
SEGMENT
Alarms
1
Open/Close
2
Bypass
3
Zone Trouble
4
Power Trouble (AC Failure or
5
Low Battery)
Siren & Telephone Fault
6
Test Reports
7
Program, Download & Log Full
8
Location 5
(Phone fault detected) 8 segments of Feature Selection Data
This location selects the partition(s) to include when reporting Special Events to email. To exclude any
partition from reporting, simply turn off the LED corresponding to that particular partition. Using Table
XI-1 on page 12, enter the corresponding number of the partition(s) to include for each type of report
found in Segments 1 – 8. Factory default is all partitions OFF.
SEGMENT
Alarm Restores
1
Telephone Fault
2
Start Download
3
Fail to Communicate, Data Lost
4
Reserved
5-8
Location 6
(Phone fault detected) 16 segments of Feature Selection Data
Reporting must be enabled in the control panel for this location to function
properly.
This location selects the partition(s) to include when reporting to a pager. To exclude any partition
from reporting, simply turn off the LED corresponding to that particular partition. Using Table XI-1 on
page 12, enter the corresponding number of the partition(s) to include for each type of report found in
Segments 1 –16. Factory default is all partitions OFF.
NX-591E
Events To Report To Email
DESCRIPTION
Special Events To Report To Email
DESCRIPTION
Events To Report To Pager
SEGMENT
Tampers
9
Short Circuit & Ground Fault
10
Sensor Lost
11
Sensor Low Battery
12
Expander Trouble
13
Failure To Communicate
14
Zone Activity Monitor
15
Reserved
16
DESCRIPTION
13