Table of Contents
Advertisement
Giant Telecom Limited – Operator Manual for 5860 – Version 0 2 29Jun2004
If both involved PP's presses [
and the second step is to release the external connection.
8.6 Handset Speakerphone (Optional)
- If Handset speakerphone option is available in the normal internal/external
X
Call, press
press
which turns on the receiver, instead of the handset speakerphone.
- During Speakerphone mode, press
normal talk mode
Press
again to stop speakerphone and go on-hooked again.
8.7 Headset
When Headset is plugged in during internal/external Call, the audio will be
routed to the headset instead of the receiver.
HEADSET OPERATION
Your cordless Handset is equipped with a 2.5 mm. Headset Jack for use with an
optional accessory headset. Contact the local store to choose a suitable headset,
refer contact to page 49.
Once you have a compatible Headset, locate the headset jack located on the side of
the Handset. First, remove the protective rubber cover. Plug the headset cord into
the jack. Do not force the connection.
When a Headset is connected, the microphone on the Handset is muted to limit the
effect of background noise.
Your cordless Handset is also equipped with a Belt Clip. Align the pins located on
the inside edge of the clip with the notches on the sides of the Handset. The belt clip
should snap securely into place.
8.8 Audio
Audio can be routed to three different outputs in the handset device: earpiece,
speakerphone and headset (through the jack-stick). The following rules will apply:
1. When hands free mode is on, the audio will always be routed to the
speakerphone.
2. When the hands free mode is off, if a headset is plugged into the jack stick,
audio will be routed to the headset.
3. If no headset is plugged in, and the hands free mode is off, the audio will be
routed to the earpiece.
] key, the first step is to terminate the conference
to start handset speakerphone. The operation is similar to
X
to toggle between speakerphone and
Page 23of 49
Advertisement
Table of Contents
