Table of Contents
Advertisement
Giant Telecom Limited – Operator Manual for 5860 – Version 0 2 29Jun2004
0 : 1 0 : 3 1
8.1.6 Temp tone dial
A user may like to change to DTMF dialing during the call if the call has been setup
for pulse dialing.
Pressing [*] for more than T1, during active call, activates DTMF dialing. This is only
enabled for the duration of the present call.
A digit 'd' will be shown on the display, indicating the 'Change to DTMF' command is
sent out.
8.2 Incoming external Call
When receiving an external call, all handsets will ring. The 'EXT' icon will flash.
The In -use/Msg LED in both handset and base will flash according to the ring
cadence.
EXT
1
1 4 : 1 5
If the network provider support caller ID, the caller's number will be shown. (See the
section of Caller ID operation for details.)
Press [
] to seize line.
User may like to reject the call by press and hold [C] for T1. In doing so, the ring tone
in handset will stop and the 'EXT' icon will remain flashing until the incoming call is
dropped. During this time, pressing the [
If auto -answer function is enabled, the line can also be automatically connected after
the handset is lifted up from base. For preventing accidental line disconnection, in
this case the users cannot press [
8.3 Internal Call Control
Internal call is initiated from a PP by depressing the [INT] key from the idle state.
INT
> B o b
W o n g
H e l e n
K w o n g
V i n c e n t
A name list is displayed and with the [5][6] – keys select the PP you want to call.
Pressing the [
] to call the selected PP.
The called PP will ring with the 'INT' icon flashing.
When the other PP takes the call the internal connection is established and the Call
time is displayed.
2 2 / 0 4
] to go on -hook within T11.
L e e
] will still seize line.
Page 20of 49
Advertisement
Table of Contents
