Table of Contents
Advertisement
Giant Telecom Limited – Operator Manual for 5860 – Version 0 2 29Jun2004
2.
Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the
eyes or skin. It may be toxic if swallowed.
3.
Exercise care in handling batteries in order not to short the battery with conducting materials such
as rings, bracelets and keys. The battery or conductor may overheat and cause burns.
4.
Charge the batteries provided with or identified for use with this product only in accordance with the
instructions and limitations specified in this manual.
5.
Observe proper polarity orientation between the battery(ies) and battery charger.
6.
Do not mix old and new batteries in this product.
7.
Do not mix batteries of different sizes or from different manufacturers in this product.
Install and Charge the Battery Pack
1
Open the battery compartment by sliding the cover down.
2
Plug the Battery Pack connector into the Handset socket, then place the battery pack and wires in the compartment.
3
Slide the battery cover back into place
4
If you are wall mounting the phone, locate the wall bracket supplied with your phone.
5
Snap the bracket into place on the back of the Base. Next, carefully line up the slots on the wall mount bracket with the
studs on the telephone wall plate, and carefully mount the telephone on the wall.
6
Connect the power supply to a live outlet. Make sure the outlet is not controlled by a switch. DO NOT connect the
telephone line cord to the phone jack until the Handset is fully charged.
7
Place the Handset in the Base cradle. The Handset and Base communicate with each other automatically. This is the
Registration process, and it may take up to 60 seconds.
8
Allow the Handset to charge for a day for the initial charge . The CHARGE indicator on the Base will glow while the
Handset is charging. For subsequent charges, 8 to 10 hours is sufficient.
5 Setup and Power Up
5.1 Normal Power Up
Connect the telephone line to the base units and the telephone sockets on
-
the wall
Connect the power adaptor between the base units and the power sockets
-
-
Plug in the battery pack into the handset compartment
-
If the handset units show battery low/empty condition, place the handsets on
the base charging cradles for some time before usage.
5.2 Handset Power On/Off
At any time in the idle mode, Long Press C /
-
power off. There is no further response in the handset, except Long Press C /
/
again.
During Handset Power Off, Long Press C /
-
again.
SAVE THESE INSTRUCTIONS
/
to make handset
/
to turn on the handset
Page 10of 49
Advertisement
Table of Contents
