Display During Call; Terminating A Call - Giant 5860 Operator's Manual

Giant Telecom Limited – Operator Manual for 5860 – Version 0 2 29Jun2004
Press [ ] to dial the number for that entry or press [OK] to append the number to
the pre-dial buffer.
Alternatively, redialing may also be done after the external line is connected. After
seizing the line, press [
[? ] and [? ] to select and then press [
number will be appended to the digits already dialed.

8.1.4 Display during call

- The 'Phone' icon will be on.
- The 'EXT' icon will be on after the PSTN line is connected. (In c ase that another
handset is connected with the PSTN line, an error tone will be generated and
handset returns to idle.)
- The 'Msg/Inuse LED' will be on in both handset and base.
If the number is longer than the maximum digits in display, the digits will appear in
the second line.
EXT
2 9 5 1 1 3 6 7 0 1 3 5 3 4 7 9
3 4 7
- Press [R]-key to flash the line to perform some PABX function and a digit 'R' will be
shown on the LCD. Long press [
The number is dialed after the 'Flash' will not be stored in the redial memory.
- After T9 of no further key press, the call timer will be shown in the second line while
the dial number shown in the first line.
The max time that can be shown is 9:59:59. When reaching this the timer will stop.
EXT
2 9 5 1 1 3 6 7 0 1 3 5 3 4 7 9
3 4 7
0 : 0 0 : 0 1

8.1.5 Terminating a call

To terminate the call, press [
will go off. The last call time will remain for T10.
Putting the handset on cradle can also terminate the call. In that case, the call time
will also be displayed for T10.
] and the last dialed number will be shown. Similarly, press
] to dial out the selected number. the redial-
] to add a pause and a digit 'P' will be shown.
]. The 'Msg/Inuse LED' in both handset and base
Page 19of 49