Restoring The Truck To Service After Maintenance And Repairs - Jungheinrich EKS 110 Operating Instructions Manual

6.7

Restoring the truck to service after maintenance and repairs

After cleaning or repair work, the truck may only be restored to operation once the
following operations have been performed.
Procedure
• Clean the truck thoroughly.
• Lubricate the truck according to the lubrication schedule, (see "Lubrication Sched-
ule" on page 86).
• Clean the battery, grease the terminals and connect the battery.
• Charge the battery, (see "Charging the battery" on page 26).
• Check the transmission oil for condensation water and replace if necessary.
• Check the hydraulic oil for condensation water and replace if necessary.
Z
The manufacturer's customer service department is specially trained to carry out
these operations.
WARNING!
Faulty brakes can cause accidents
As soon as the truck has been started, test the brakes several times.
Report any defects immediately to your supervisor.
Tag out and decommission a faulty lift truck.
Only return the truck to service when you have identified and rectified the fault.
• Start up the truck, (see "Starting up the truck" on page 39).
Z
If there are switching problems in the electrical system, apply contact spray to the
exposed contacts and remove any oxide layers on the contacts of the controls by
applying them repeatedly.
95