National Alloy Assembly Instruction

For Desk to Desk Connections begin at step 1
For Desk to Storage with Spacer configurations begin at step 4
For Desk to Storage without Spacer configurations begin at step 7
For Desk to Desk Connection
Verify that the powered beam and ganging kit are completely installed
1
and the two units to be ganged together. For Fixed Height ganging skip to
step 3. For Adjustable Height continue to step 2.
Run the jumper through the wire pass-through on both crosslink rails.
2
Connect one end of the ganging jumper to the first powered beam phase
block. Connect the opposite end of the ganging jumper to the first phase
block on the second unit. (Figure A)
Figure A:
Connect one end of the ganging jumper to the first powered beam open
3
phase block connection. Connect the opposite end of the ganging jumper
to the first open phase block connection on the second unit.
Note: Verify all connections have been fully seated and "clicked"
into proper position before powering unit.
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service
Phase Block
Wire Pass-Through
Ganging Jumper
Assembly Instruction
Alloy
Ganging Jumper
Package Contents
Ganging Jumper
Telephone 800.482.1717
Fax 812.482.8800
www.NationalOfficeFurniture.com
Part # 2891776
Rev, A
Printed in U.S.A
© 2014 Kimball International, Inc.
.
800.482.1717
Qty
1