National Alloy Assembly Instruction

Note: This instruction will cover the assembly of hardwire fixed height
center beams.
With the center beam upside down. Remove both hardwire junction boxes
1
from the center beam as shown in Figure A.
Figure A:
Remove the four screws securing one U-Channel to the center beam as
2
shown in Figure B.
Figure B:
Have a licensed electrician wire and install the junction boxes on the center
3
beam in the desired configuration. Re-install the U-Channel and junction
box / cover in reverse order of steps 1 &2.
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service
Assembly Instruction
Alloy
Fixed Height
Single Center-
Beam Hardwire
Package Contents
Hardware
#8 x 1 Wood Screw
Self Driving Screw
Tools Required
Screw Driver
#2 Phillips Driver
#3 Phillips Driver
Telephone 800.482.1717
Fax 812.482.8800
www.NationalOfficeFurniture.com
Part # 3057149
Rev, -
Printed in U.S.A
© 2014 Kimball International, Inc.
.
800.482.1717
Qty
16
4