National WaveWorks Assembly Instructions

Place pedestal on its side. Thread a
1 1
caster into each threaded mount on
the bottom of the pedestal (Figure A).
Place washer and nut onto each caster
2 2
stem and tighten (Figure B). Stand
pedestal upright.
Removing Pedestal Box Drawer:
3 3
Extend drawer fully. Put one hand
underneath the drawer. Insert a flat
head screwdriver between the slide
and drawer body close to the front
engagement area to unlock drawer
(Figure C).
Lift front of drawer up to disengage
4 4
from front drawer slide channel hooks.
When front of drawer is disengaged, pull
entire drawer towards you, supporting it
from the bottom. This should disengage
drawer from rear drawer slide channel
hooks (Figure D).
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent. If you
have any questions concerning these instructions, please call National Customer Service.
Figure A
Figure B
Nut
Washer
Pedestal Frame
Caster
Figure C
Figure D
C C A A S S E E G G O O O O D D S S
Assembly Instructions
WaveWorks®
Metal Mobile Pedestal
Recommended Tools
• Drill
• 1/4" and #2 Phillips tip bits
• Flat head screwdriver
• Round metal file
• Center punch
Package Contents
• Pedestal
• Casters
• Washers
• Nuts
Telephone 800.482.1717
Fax 812.482.8800
www.nationalonline.com
Part # 2010777
Printed in U.S.A
© 2006 Kimball International, Inc.
Qty.
1
4
4
4